Console

The console offers an ability to switch debug options of Sanny Builder. Mostly they relate to the disassembler features and you can see the changes when disassemble a file. The console window is open after pressing Ctrl+~. You may enter the commands in the input line. After typing a command press Enter to proceed. The console will display a result.

Available commands

All commands are case-insensitive.

help – shows the help information about the console clear – clears the console list – shows in the console the list of all commands list options – lists all available debug options toggle [on/off] – enable or disable debug options

The input command ends either with the word ON (the option will be enabled) or OFF (the option will be disabled), or nothing (the option will be toggled from ON to OFF or from OFF to ON).

Before enabling the following options turn on the debug mode with the command toggle debug_mode ON

Debug Options

CODE_OFFSETS

The disassembler prints the offset of each command.

VAR_COUNTER

After compiling the console contains the list of the global variables used only once in the code (i.e. can be removed or replaced with local variables).

IGNORE_UNKNOWN

The disassembler ignores unknown opcodes, incorrect parameters and so on. It helps to open almost any file that used to be protected or compiled incorrectly.

CONSTANT_INDEXES

The disassembler prints array elements as global variables with indexes. It's available for GTA SA, LCS, VCS games.

E.g. given an array of three elements starting at $10 this option affects the way the variables look like after disassembling:

SKIP_SCM_HEADER

Disassembler skips the header of the input file. It allows to open headless scripts (e.g. the ones from script.img or CLEO scripts).

With this option the compiler makes .scm files without the header (similar to {$EXTERNAL} directive).

SKIP_EXTRA_INFO

The disassembler ignores the extra info section attached to the input file. It also treats this section as a set of regular SCM instructions, so enabling IGNORE_UNKNOWN option is recommended.

Alternate ways

Sanny Builder offers a few other ways to toggling debug options outside of the console that might be useful in some cases.

Running with --debug

The --debug option provides an alternate way of switching the debug options. Run Sanny with the parameter --debug X, where X is a series of 0 and 1. Each digit in the series corresponds to a particular debug option:

sanny.exe --debug 110000

The first 1 enables the CODE_OFFSETS option, the second 1 enables the IGNORE_UNKNOWN mode. The remaining options are disabled.

Using GUI

Clicking the right-most button in the main toolbar shows a drop-down menu with the list of debug options.

Each menu item toggles a particular debug option. The change comes into effect immediately.

Last updated